Kucht KPD361F Manuel d'utilisateur télécharger pdf (Page 8)

If local codes permit, a flexible metal appliance connection with the

new AGA or CGA certified design, max. 5 feet (1,5 m) long, 34" I.D.

is recommended for connecting this appliance to the gas supply line.

Do not bend or damage the flexible connector when moving the

appliance.

This appliance must be used with the pressure regulator provided.

The regulator shall be properly installed in order to be accessible

when the appliance is installed in its final location. The pressure

regulator must be set for the type of gas to be used. The pressure

regulator has 34" female pipe thread. The appropriate fitting must be

determined based on the size of your gas supply line, the flexible

metal connector and the shutoff valve.

The appliance must be isolated from the gas supply piping system

by closing its individual manual shutoff valve during any pressure

testing of the gas supply piping system at test pressures equal to or

less than 34 PSI (13,8 w.c. pr 3,5 kPa).

All opening and holes in the wall and floor, back and under the

appliance shall be sealed before installation of the appliance.

TYPE OF GAS

This appliance is shipped from the factory for use with natural gas.

For use with propane LP gas please follow the conversion procedure

step by step, conversion procedure is also included with each set of

LP gas nozzles.

GAS PRESSURE

The maximum inlet gas supply pressure incoming to the gas

appliance pressure regulator is 34 PSI (13,8 w.c. pr 3,5 kPa).

The minimum gas supply pressure for checking the regulator setting

shall be at least 1" w.c. (249 Pa) above the inlet specified manifold

pressure to the appliance (this operating pressure is 4" w.c.

(1.00 kPa) for Natural Gas and 10" w.c. (2.75 kPa for LP Gas).

IMPORTANT SAFETY INSTRUCTIONS

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 40 41

Pas de commentaire

Kucht KPD361F Manuel d'utilisateur Page 8